TIGI Bed Head Luxe Lip Gloss for Women, Sugar Dust, 0.11 Ounce

mom liked it alot

the screw on lid with the applicator has broken

I’m assuming the reason you’re here is because you got yourself an aftermarket security system and it has the ability to open your trunk and you didn’t have this ability stock and you want to add it. If that’s the case read on, if not, this will still work for you as a replacement and that’s all you need to know.I bought this because I had wanted to put a security system in my Toyota that didn’t come with one. I had my viper kit installed and after the fact installed this myself as it would’ve cost way too much for the amount of work it took. However it took me a lot of thinking so I’m going to try to save you the extra heart ache and tell you how to wire this up.It fits right in like it should but when you wire it up it’s not going to work right. Aftermarket security systems for accessories like lock, unlock, trunk, etc functions send out or recieve a ground signal. The trunk actuator is going to want to be switched by a +12v signal. I went through all the testing phases to try and figure out why and all I could figure out is that you’re going to need a relay to give each component the signal that it needs.I know this sounds complicated but it’s actually easier than it sounds. The relay you’ll need will have four pins, two to engage the coil and two to create a path to the actuator. I recomend you get the same wire terminal pieces that work with the relay you get from your local autozone.For starters you need to send a CONSTANT +12v DC signal to the coil of the relay. You’ll probably have to send one back there, which kinda sucks, but that’s not terribly hard either. Go from your fuse box or just patch into you 12v outlet near the center console. Don’t worry about your fuses because this actuator doesn’t need much power to work anyway. Route the wire along the driverside doorpanel amd through a small whole in the corner of the rear bench seat. Go up through the roof of your trunk and stick the wire inbeetween all the other wires going to the trunk lid.Once you’ve done that, you’ll route the ground from your security system trunk signal to the GROUND of the coil. This will create a path when you engage the trunk button on your remote. Once you’ve done all this, the rest is easy. You’ll short the terminal that you just created with the +12v DC to the contactor. Should take no more than 6 inches of wire. Once this is done, send the remaining contactor to the +12v wire from the wiring harness on your car.NOTE: I never like cutting factory wires as this is permanent so I went to my local Pull-A-Part and got a wiring harness for cheap.I know you wished this would be easier but since I’m assuming you’re a lower trim Camry you didn’t come with the trunk function from the factory. Once this is done, make sure your connections are tight and you’re all set.This is just going to pop the trunk open so if you want it to open most of the way you can YouTube bungie cord trunk opener or something like that. This is a mod that will open your trunk nearly all the way. I’ve had mine for years and it’s worked for me as long as you don’t get super cheap bungie cords.

I love Tigi, especially Bed head products. This gloss smells great & leaves your lips shiny and lightly tinted.

Multi pack for good price. Received quickly.

I put this trunk lock unit into my 2015 Chrysler 300. Fit like a glove, took minutes to put in. The dealership suggested price for the part was $300 and you’d have to figure at least an hour for labor with them, plus tax. So I look at it as saving me $400 to do in my driveway, versus taking it to a dealership. This made me a big hero with the wife, never a bad thing!