Jean Couturier Coriandre Women PDT Spray (Refill) 3.3 oz
- All prices mentioned above are in United States dollar.
- This product is available at Amazon.
- At amazon.com you can purchase Canamax Premium 5303281153 & 134503600 Dryer Rear Bearing - Exact Fit for Frigidaire & Kenmore Dryers - Replaces PS459829 AP2142648 PS1148434 134163400 for only $19.49
- The lowest price of Canamax Premium 5303281153 & 134503600 Dryer Rear Bearing - Exact Fit for Frigidaire & Kenmore Dryers - Replaces PS459829 AP2142648 PS1148434 134163400 was obtained on August 4, 2024 9:19 am.
Set Lowest Price Alert
×
Notify me, when price drops
Set Alert for Product: Canamax Premium 5303281153 & 134503600 Dryer Rear Bearing - Exact Fit for Frigidaire & Kenmore Dryers - Replaces PS459829 AP2142648 PS1148434 134163400 - $19.49
Jean Couturier Coriandre Women PDT Spray (Refill) 3.3 oz
$19.49
Description
The best price for Jean Couturier Coriandre Women PDT Spray (Refill) 3.3 oz
- Launched by the designer house of jean couturier
- It is suitable for all skin types
- Truly femmenine fragrance
- Keeps you all day fresh
- It is recommended for daytime wear.
Additional information
Specification: Jean Couturier Coriandre Women PDT Spray (Refill) 3.3 oz
|
Price History
-
Reviews (15)
15 reviews for Jean Couturier Coriandre Women PDT Spray (Refill) 3.3 oz
Show all
Most Helpful
Highest Rating
Lowest Rating
Add a review
Related Products
Mckayla –
Product came nicely packaged to prevent damage to the element. This igniter does not come with the mounting bracket so the original bracket must be used. This can be replaced to fix a dryer that isn’t heating.Replacement is simple, begin by lifting the top panel of the dryer. Next, remove the two screw that hold on the front panel at the top. Pull the front panel away from the clips. My dryer panel had to be pulled upwards off of the clips to be removed. Once removed, depress the tensioner pulley on the belt to slide the belt off of the motor. This will allow you to remove the drum and get better access to the igniter as the igniter is very fragile. Unplug the old igniter, unscrew the mount and remove the assembly. Unscrew the old igniter from the bracket and screw the new one in until the igniter can not be moved from side to side. Do not overtighten the mounting screw. At this time, wipe off any residue that may be built up on the flame sensor or the flame eye. This is a small piece that is normally right beside the igniter. Also take the time to clean out any lint and debris from inside the cabinet. Finally, carefully slide the new igniter into place and screw the mount in. Plug the igniter in and put dryer back together. Slide the drum into place (this may be easier with two people) and slip the belt back over the motor by depressing the pulley. I would also recommend replacing the belt while you already have the drum out, but it might not be necessary. Place front panel back on and push the top back down into place.****Always remember to disconnect power and shut the gas to the dryer off prior to working on the unit.Front panel also has a door latch sensor that must be unplugged prior to removing the panel. Take a picture or mark these wires to ensure they are plugged back in the proper way.
Annick MORIER –
j’adore ce parfum c’est pourquoi j’en fais une grosse consommation et tout le monde ne le porte pas
Annick MORIER –
j’adore ce parfum c’est pourquoi j’en fais une grosse consommation et tout le monde ne le porte pas
paget –
I have no idea if this is authentic. I have never smelled the real thing in a store. The bottle was packaged inside a box without exterior wrap and had no cap. The outside of the box was labeled “Recharge”. Whatever that means. Maybe it was intended as a tester. The number on the bottom read: 19071901. I do not know what this means. Scent is just okay. Doesn’t last. Sent to thrift store.
paget –
I have no idea if this is authentic. I have never smelled the real thing in a store. The bottle was packaged inside a box without exterior wrap and had no cap. The outside of the box was labeled “Recharge”. Whatever that means. Maybe it was intended as a tester. The number on the bottom read: 19071901. I do not know what this means. Scent is just okay. Doesn’t last. Sent to thrift store.
Letty –
Excellent!Conforme!livraison rapide et bien emballé.
Cel833 –
Très on parfum
Tammy –
I didn’t install it, my brother-in-law did. He had no complaints, all went as it should have!
DAN –
DO NOT REUSE YOUR DRUM’S ‘NIPPLE BEARING’ SCREWS WHEN REPLACING! They are different threads. The factory Kenmore comes with self tappers and this kit has machine screws with complementing threads on the nipple bearing. I broke one of the kit’s screws off before I realized but I just drilled it out and used a number 8 or 10 screw+nut
Doesn’t work –
It’s been installed for two weeks without issues. I will revise review if any problems occur
Ryan snook –
The igniter showed up packaged really well and works great.
TimJ –
Replaced on my whirlpool dryer. Exact fit and easy to install
J&Kworks LLC –
Every thing I ordered was delivered when promised and was the right part for the job.The Amazon app made it easy.
Patrick M. –
The media could not be loaded. The OEM this reservoir replaced was more than four times the price, and lasted 13 months. This Amazon reservoir seems sturdy, and the fit was perfect.
Kindle Customer –
Exact match.