Emoji I Love My Wild Friends 2 Piece Gift Set for Kids

Product came nicely packaged to prevent damage to the element. This igniter does not come with the mounting bracket so the original bracket must be used. This can be replaced to fix a dryer that isn’t heating.Replacement is simple, begin by lifting the top panel of the dryer. Next, remove the two screw that hold on the front panel at the top. Pull the front panel away from the clips. My dryer panel had to be pulled upwards off of the clips to be removed. Once removed, depress the tensioner pulley on the belt to slide the belt off of the motor. This will allow you to remove the drum and get better access to the igniter as the igniter is very fragile. Unplug the old igniter, unscrew the mount and remove the assembly. Unscrew the old igniter from the bracket and screw the new one in until the igniter can not be moved from side to side. Do not overtighten the mounting screw. At this time, wipe off any residue that may be built up on the flame sensor or the flame eye. This is a small piece that is normally right beside the igniter. Also take the time to clean out any lint and debris from inside the cabinet. Finally, carefully slide the new igniter into place and screw the mount in. Plug the igniter in and put dryer back together. Slide the drum into place (this may be easier with two people) and slip the belt back over the motor by depressing the pulley. I would also recommend replacing the belt while you already have the drum out, but it might not be necessary. Place front panel back on and push the top back down into place.****Always remember to disconnect power and shut the gas to the dryer off prior to working on the unit.Front panel also has a door latch sensor that must be unplugged prior to removing the panel. Take a picture or mark these wires to ensure they are plugged back in the proper way.

Dryer quit heating so I scheduled a repairman, was told minimum $170.00 if it was the igniter.I googled the issue, it also pointed to the igniter, I ordered the universal igniter $20.00 knowing I could return it if it didn’t work or fit and reschedule repairman.It was a somewhat easy install and now works perfectly.Doing it myself I saved $150.00. Well worth the little extra work for me

**Update to say that the customer service is fantastic. We have an 2016 Malibu and even though Amazon says they will work it doesn’t. Wee have came to the conclusion that there are multiple frequencies for that year.After these were installed they went bad. They registered and worked when we left the tire shop, but after about 15 miles of driving, they stopped working.

This part was a bit more expensive then some of the plastic or other no name brand equivalents, but Dorman is a well known brand do I didn’t mind. The part was all aluminum instead of plastic like OEM and came with all gaskets and an orange cap to let you know it’s an upgraded part and which specific filter you need to use. It came with a filter and all instructions for mounting and torque specs too. Installation was super easy, I watched a video on YouTube as well. Was a replacement for my 2013 Dodge grand caravan that was leaking oil. Was able to install in an afternoon an no more leaks. Definitely better quality then plastic part. Am 100% satisfied with this product. Hopefully don’t have to worry about it again.

Value for the money – this is a great brand and the price is really good. It was easy to install, but I did run across a few issues on installation only because my vehicle engine is a bit difficult to deal with, not the product. This brand is a quality brand and have used it in the past.

These sometimes fail , the price allowed me to purchase more cheaper than factory by far they appear to be good quality . I did not try to use any warranty I just purchased another set came quickly am on the road again saved me a lot of money and my tire store worked with me on installation price . I purchased Oem that individually cost me for one as both sets cost me . They work.